China MS Certificate Holders CO. custom certificate holders

We are the manufacturer of certificate holders, certificate cover, certificate folder, certificate booklet, passport booklet, irst cut and cut the sheet by size

Cut the board according to the planned dimensions of the drawing, slotting, hollowing, etc.

The next good material is assembled and reinforced, and the size must be high precision without deviation, no gaps, etc.

Cut some parts of the dark layer (organ) of the box and empty it at the desired location

Then make one long and one short piece of wood as shown below, and the angle of the bevel should be mastered, then fix a short piece of glue to the groove; place a long piece of wood on the groove and place a piece of copper. And stick it tightly, and finally stick the stick to the top of the short strip of wood. The end of the piece of copper should be higher than the sheet.

Then drill holes in the inside of the box as shown in the figure, place the spring as the power part of the mechanism, and then reinforced the partition on the dark layer of the wooden box.

After the glue is dry and adhered, the wooden box is chamfered as shown below, and then reinforced by the boring process, and finally the excess is cut and polished to a flatness.

Cut the polished box to the specified size (the lid and the box are separated)

Use the equipment to make several L-shaped small parts as shown below as thwholesale supplier in China. certificate holder supplier

Welcome to contact us and pls visit our website:

www.customcertificateholder.com certificate folder manufacturers