24.XKHR-1000 Ash Fusion Analyzer

Ash Melting Point Detector

Product Name: Ash fusion analyzer

Product Type: XKHR-1000

Scope:

XKHR-1000 Ash fusion analyzer and silicon tubes form a complete set of high temperature furnace, is laboratory for determination of ash fusion of intelligent laboratory equipment. Suitable for the determination of coal ash fusion, and the melting process of non-single compound no fixed melting point was measured, the instrument can be widely applied in electric power, coal, metallurgy, tobacco, petrochemical, coal chemical, environmental protection, cement, paper, geological exploration, research institutes and other industries, in line with the national standard GB / T219-2008 "Determination of ash fusion of" requirements.It may be within a certain range of control parameters to select and modify, but also with the timing of the thermostat can be set RS232 communication procedures and standards.

Features:

1. For the determination of the melting characteristics of coal ash.

2. Process control, according to the national standard AutoComplete ash melting point of the heating process.

3. With a variety of failure prompts, easy to operate, reliable performance.

4. In line with the national standard GB / T219-2008 "Determination of ash fusion of" relevant regulations.

Technical parameters:

Highest temperature: 1500 ℃ ± 3 ℃

Measurement error: ± 3 ℃

Temperature: Before 900 ℃ to 15 ~ 20 ℃ / min

After 900 ℃ to 5 ℃ ± 1 ℃ / min

Timing error: less than 1s/h

Power supply voltage: AC220 (1 ± 10%) V, 50Hz

Maximum current: 30A

Work mode: Continuous

Temperature range: 0 ~ 1600 ℃, resolution 1 ℃, equipped with S value thermocouple.

Time range: 0 ~ 999min, resolution 1min (less than 10min when 1s).

Control: microcontroller as the core, automatic calibration to measure the temperature and current, automatic closed-loop control thyristor phase-shift trigger heating current.

Environment: Temperature 0～40℃, relative humidity less than 80%;